how to configure cisco 2950 switch step by step

How to configure cisco 2950 switch step by step how to#
How to configure cisco 2950 switch step by step mod#

For example, VLAN 100 does not exist in the output of the show vlan brief command. If VLAN does not exist the switchport access vlan command forces the creation of a VLAN on the switch. Following is the syntax for defining a port to be an access port and assigning it to a VLAN. Only in one case when the access port is connected to an IP phone, there are two VLAN associated with this port, one for voice and one for data.

How to configure cisco 2950 switch step by step mod#

Port in access mod can belong to only one VLAN at a time. Once VLAN configuration is done, then the next step is assigning ports to the VLAN. Sw-2(config)# vlan 50-60 Assigning Ports to VLAN Use the following command to create VLANs 10, 20, 30, 40, and VLANs 50-60. The IDs can be entered separated by commas and the range of VLAN IDs can be separated by hyphens for example “vlan vlan-id”. So, we can create VLANs one by one, using a series of VLAN IDs and using a range. Now we should create some VLANs including VLAN-10 and VLAN-20 on Sw-2. The figure below illustrates the topology where Sw-1 has already been configured with VLAN 10 and 20. We can check using the Syntax Checker show vlan brief command in user exec mode to display the contents of the vlan.dat file. Naming each VLAN is the best practice in VLAN configuration. The figure below illustrates the Cisco IOS command syntax used to add a VLAN to a Cisco switch and give it a name. Flash memory does not need the copy running-config startup-config or write command.īut, other details are usually configured on a Cisco switch at the same time when VLANs are created it is best to save running configuration changes to the startup configuration. dat file, which is located in flash memory on the switch. Normal range VLAN configuration is stored in vlan. In the previous article, we have discussed the normal and extended-range VLANs.

How to configure cisco 2950 switch step by step how to#

CCNA VLAN Configuration in Cisco SwitchesĪsad Ijaz basic vlan configuration, ccna vlan configuration, Changing VLAN Port Membership, cisco no vlan, cisco show interface vlan membership, cisco switch vlan configuration, cisco vlan configuration, configure a vlan, creating vlans and assigning ports, delete vlan dat, deleting ports from vlan, how to check vlan detail, how to configure a vlan, how to configure a vlan on cisco switch, how to configure vlan, how to configure vlan command, how to configure vlan in cisco packet tracer step by step, how to configure vlan on cisco switch 2960, how to configure vlan step by step, how to create a vlan on a cisco switch, how to delete vlan dat, how to delete vlan in cisco switch 2960, show vlan brief, show vlan brief command, show vlan commands, show vlan ip address, show vlan summary, vlan configuration, vlan configuration command, vlan configuration guide, vlan configuration in switch, vlan configuration recommendations, vlan configuration step by step command pdf 1 Comment August 16, 2019